Product DescriptionThe KXTJ2 is a tri-axis +/-2g, +/-4g or +/-8g siliconmicromachined accelerometer. The sense element isfabricated using Kionix’s proprietary plasmamicromachining process technology. Accelerationsensing is based on the principle of a differentialcapacitance arising from acceleration-induced motion ofthe sense element, which further utilizes common modecancellation to decrease errors from process variation,temperature, and environmental stress. The senseelement is hermetically sealed at the wafer level bybonding a second silicon lid wafer to the device using aglass frit. A separate ASIC device packaged with thesense element provides signal conditioning and digitalcommunications. The accelerometer is delivered in a 2 x2 x 0.9 mm LGA plastic package operating from a 1.8 –3.6V DC supply. Voltage regulators are used to maintainconstant internal operating voltages over the range ofinput supply voltages. This results in stable operatingcharacteristics over the range of input supply voltages and virtually undetectable ratiometric error.The I2C digital protocol is used to communicate with the chip to configure the part and monitor outputs.

Product SpecificationsTable 1. Mechanical(specifications are for operation at 2.6V and T = 25C unless stated otherwise)Parameters Units Min Typical MaxOperating Temperature Range ºC -40 - 85Zero-g Offset mg - ±25 ±200Zero-g Offset Variation from RT over Temp. mg/ºC 0.2Sensitivity (14-bit)1,2 GSEL1=1, GSEL0=1 (± 8g) counts/g 1024Sensitivity (12-bit)1GSEL1=0, GSEL0=0 (± 2g)counts/g1024GSEL1=0, GSEL0=1 (± 4g) 512GSEL1=1, GSEL0=0 (± 8g) 256Sensitivity (8-bit)1GSEL1=0, GSEL0=0 (± 2g)counts/g64GSEL1=0, GSEL0=1 (± 4g) 32GSEL1=1, GSEL0=0 (± 8g) 16Sensitivity Variation from RT over Temp. %/ºC 0.01Self Test Output change on Activation(Negative Self-Test)4 g0.1 (x)-0.3 (y)-0.4 (z)Self Test Output change on Activation(Positive Self-Test) 41.0 (x)0.8 (y)0.6 (z)Mechanical Resonance (-3dB)3 Hz 3500 (xy)1800 (z)Non-Linearity % of FS 0.6Cross Axis Sensitivity % 2Noise Density g / √Hz 350Notes:1. Resolution and acceleration ranges are user selectable via I2C.2. 14-bit Resolution is only available for registers 0x06h – 0x0Bh in the 8g Full Power mode3. Resonance as defined by the dampened mechanical sensor.4. Negative or Positive self-test polarity can be exercised by