深圳安盛宇电子有限公司

The STM8S001J3 8-bit microcontrollers offer 8 Kbytes of Flash program memory, plus integrated true data EEPROM. It is referred to as low-density device in the STM8S microcontroller family reference manual (RM0016). The STM8S001J3 device provides the following benefits: performance, robustness and reduced system cost.
Device performance and robustness are ensured by true data EEPROM supporting up to 100000 write/erase cycles, advanced core and peripherals made in a state-of-the-art technology at 16 MHz clock frequency, robust I/Os, independent watchdogs with separate clock source, and a clock security system.
The system cost is reduced thanks to a high system integration level with internal clock oscillators, watchdog, and brown-out reset.
Full documentation is offered as well as a wide choice of development tools.

All features
Core
16 MHz advanced STM8 core with Harvard architecture and 3-stage pipeline
Extended instruction set

Memories
Program memory: 8-Kbyte Flash memory; data retention 20 years at 55 °C after 100 cycles
RAM: 1 Kbyte
Data memory: 128-byte true data EEPROM; endurance up to 100 k write/erase cycles

Clock, reset and supply management
2.95 V to 5.5 V operating voltage
Flexible clock control, 3 master clock sources
External clock input
Internal, user-trimmable 16 MHz RC
Internal low-power 128 kHz RC

Clock security system with clock monitor
Power management
Low-power modes (wait, active-halt, halt)
Switch-off peripheral clocks individually
Permanently active, low-consumption power-on and power-down reset

Interrupt management
Nested interrupt controller with 32 interrupts
Up to 5 external interrupts

Timers
Advanced control timer: 16-bit, 2 CAPCOM channels, 2 outputs, dead-time insertion and flexible synchronization
16-bit general purpose timer, with 3 CAPCOM channels (IC, OC or PWM)
8-bit basic timer with 8-bit prescaler
Auto wakeup timer
Window and independent watchdog timers

Communications interfaces
UART, SmartCard, IrDA, LIN master mode
SPI unidirectional interface up to 8 Mbit/s (master simplex mode, slave receiver only)
I2C interface up to 400 Kbit/s

Analog to digital converter (ADC)
10-bit ADC, ± 1 LSB ADC with up to 3 multiplexed channels, scan mode and analog watchdog
Internal reference voltage measurement

I/Os
Up to 5 I/Os including 4 high-sink outputs
Highly robust I/O design, immune against current injection

Development support
Embedded single-wire interface module (SWIM) or fast on-chip programming and non-intrusive debugging